Lots of broken strings

[Joe & Penny Goss]

Phil,
I have found that if only one string breaks you need to re tune the octave
surrounding that note. And yes that many broken strings will send the rest
of the strings very sharp. Even leaving them out of tune after the broken
strings have been pulled up to pitch some times sharp some times flat
depending on the structure of the piano,
Joe Goss
----- Original Message -----
From: pryan2 <pryan2@the-beach.net>
To: <pianotech@ptg.org>
Sent: Saturday, February 12, 2000 6:04 PM
Subject: Lots of broken strings


> I was sent to tune a nice U1 Yamaha piano in a Gospel-type church which
had
> six broken bass strings.  All had broken at the v-bar and showed no rust.
> The pianist was very upset about it (actually the price of replacement),
as
> broken strings  have become a regular occurrence.  I chided her that she
> must be playing with a heavy left hand, but when I tuned the piano, I
found
> the wound section to be 20 to 31 cents sharp.  My question is, could
> someone have tuned this piano that sharp, or did the missing strings shift
> the balance of pressure on the bridge or something to that extent (a la a
> violin)? Should I look elsewhere?  The middle and treble sections of the
> piano were  tuned to accurate pitch.  Secondly, is 20 to 31 cents sharp
> enough to break a good wound string?  I always thought they were made to
> withstand a lot more stretching than that.
>
> Phil Ryan
> Miami Beach, FL
> -----------------------------------------------------
> Click here for Free Video!!
> http://www.gohip.com/freevideo/
>
> ----- Original Message -----
> From: "Martin Dubow" <tuner@mediaone.net>
> To: <pianotech@ptg.org>
> Sent: Friday, February 11, 2000 7:09 PM
> Subject: Re: hale hammer
>
>
> > Terry -
> >
> > The address for Pacific Piano Supply is:
> >
> > 16119 Cohasset Street
> > Van Nuys, Ca. 91406
> > 818 779-1586
> >
> > Martin
> >
> >
> > pianolover@worldspy.net wrote:
> >
> > > I noticed earlier today, when tuning the Yamaha Grand, that the tip
(#2)
> on my Hale hammer was really too short for tuning the Grands, especially
up
> in the high treble area. In addition to getting a longer tip,(which will
> give me more clearance) I want to buy another head (5 degree), and put
them
> together for quick changes. If A hale tip and head are not available, can
> anyone suggest what will fit the shaft of my Hale hammer? The head and tip
I
> currently have (#2, and head is 10 degree) work great on verticles, but I
> think the 5 degree head and longer tip would work better on Grands. I
guess
> I'll have to make a trip up to Pacific Piano for the stuff...anyone know
the
> address? Thanks.
> > >
> > > Btw, I bought the hammer from my mentor, who says the head has not
been
> off the shaft for ten years..that would explain why it WON'T come off! I
> soaked the area with WD40, but it still wont budge..I'll have to try
putting
> it in a vice. If it's rusted on, maybe i can just buy a new shaft in
> addition to the new head & longer tip, and then just have that ready to
> switch. Any ideas?
> > >
> > > Terry
> > >
> > > ______________________________________________________________
> > > Get free Internet service and email at http://www.worldspy.com
> >
> >
>
>