At 10:23 PM 12/20/2000 -0500, you wrote: >Kevin wrote; > <<"Where do you buy >one of these wonder thingees.???">> > Well I got mine from Grizzly Industrial. It cost 29.95 plus shipping of 5.95 > for a total of 35.90. The thing weighs a heck of a lot and the maching is >not all that fine but it works well and performs all that I want it to. > > The throw is only 3 inches so I don't think that it would work for >backchecks although it would for pressing capstans in new keysticks or when >the capstans have been relocated. I don't think that Del meant if you were >just replacing capstans in the same hole you could press them in...but I >could be wrong...Del? >Jim Bryant (FL) I got one from AMT back when the earth was young, at what I remember as a similar cost. I used it for punching hundreds of player gaskets, with my elf made rule dies, and general mashing operations. It has a throw of more like 6", but I haven't used it for much lately. That's the problem with this continuing education thing. I have to keep digging out this old stuff and reevaluating all the time. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC