Greetings - I recently joined the on-line group and I really appriciate the discussion and information.... I wanted to ask a question about tightening pinblock and rim plate screws. I have been using a phillips and/or flat head screw driver bit that you can fit into your tuning hammer. I think I got them from Schaff. I have usually found though that the screws that I am using them on are larger than the screw driver tips. I end up nicking the crome screw tops or, worse yet nicking the plate, trying to wrench down on them. I noticed yesterday that the phillips head has gotten so chewed up that it's nearly unusable. Is there another supplier for this kind of tool that you can use in a tuning hammer that fits better in these large screws? What is everybody else using? There has got to be a better mouse trap, if you know what I mean... Thanks! Brian Janey, Fallbrook, CA San Diego County PTG Chapter
This PTG archive page provided courtesy of Moy Piano Service, LLC