This is the procedure, in use in our shop, for levelling plates that are supported on dowels. With old pin block still in place and new sound board 'in', install plate on nose bolts set at original heights above posts. Fasten plate to pin block. Check to assure all plate bolt bosses are above (not touching) new sound board. Determine down bearing and bridge heights. Log measurements from rim top to each plate bolt hole. Remove plate. Mike (measure) plate thickness at each plate bolt hole.. These measured thickness', added to the measured distances from rim top to top of each plate bolt hole, is the distance from rim top to top of dowels that support the plate. Dowels can then be installed and cut to measured height. Joe Brown and Lew Jones lewjone@prodigy.net Shop is at Smyrna, DE.
This PTG archive page provided courtesy of Moy Piano Service, LLC