Thanks for the good response, Del. Case closed, reply flagged for archiving. I especially liked the "rule of thumb", referenced below. At 08:02 PM 3/31/99 -0800, you wrote: > My rule of thumb is that the string should not be any higher on the pin than it >was on the bearing bar that used to be there. This generally places the string no >higher than 6.0 mm from the plate surface and usually a bit lower -- around >4.0 to 5.0 mm is generally about right.. > >Del Jim Harvey Greenwood, SC harvey@greenwood.net ________ The box said 'Win95, NT, or better', so I used Linux
This PTG archive page provided courtesy of Moy Piano Service, LLC