> Date: Sun, 30 Mar 1997 20:01:35 -0500 (EST) > From: Jon Page <jpage@capecod.net> > Subject: plate spraying: finishing > To: pianotech@byu.edu > Reply-to: pianotech@byu.edu Or simply mask it with thin tape... David ilvedson Pacifica, CA PS...If replies could start out at the top of the post it would make my life a little easier. > Note: > File paint off of the pressure ridge near the tuning pins. > Otherwise you will be left with a chipped edge or unwanted > impressions. Don't change the height, just remove the finish > for a clean metallic edge for the wires to go over. > Neatness counts. > > Jon Page > Harwich Port, Cape Cod, Mass. (jpage@capecod.net) > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC