Newton I finally completed the job. After receiving the new specs from you, I sent them off to David Sanderson Newton Hunt wrote: > > COLE_O String Winding Data > > NOTE CORE OUTER INNER OUTER LENGTH OF LENGTH OF LENGTH OF > DIAM WRAP WRAP DIAM TAIL WRAP TAIL+WRAP > > 31 .037 43.0 .048 6 3/16 37 7/16 43 10/16 > 31 .037 43.0 .048 6 9/16 37 7/16 44 0/16 > > 30 .038 43.0 .049 6 2/16 38 0/16 44 2/16 > 30 .038 43.0 .049 6 8/16 38 0/16 44 8/16 > > 29 .038 40.0 .051 6 3/16 38 8/16 44 11/16 > 29 .038 40.0 .051 6 9/16 38 8/16 45 1/16 > > 28 .038 38.0 .053 6 4/16 38 12/16 45 0/16 > 28 .038 38.0 .053 6 9/16 38 12/16 45 5/16 > > 27 .039 34.0 .059 6 2/16 39 1/16 45 3/16 > 27 .039 34.0 .059 6 8/16 39 1/16 45 9/16 > > 26 .039 33.0 .061 6 0/16 39 3/16 45 3/16 > 26 .039 33.0 .061 6 7/16 39 3/16 45 10/16 > > 25 .041 33.0 .063 0 0/16 39 10/16 39 10/16 > 25 .041 33.0 .063 0 0/16 39 10/16 39 10/16 > > > Well, Tom, here it is. The tension is a little off here and there, but this > should give you durability, nice tone and nice transition from middle to bass > section. > > Outer wrap is in wire gauge sizes, not in mils (.001"), for the winder. > > Please varify the tail length to your measurements to make sure there are no > errors there. > > Hope this works out for us all. > > Newton > nhunt@rci.rutgers.edu -- Thomas A. Cole, RPT Santa Cruz, California
This PTG archive page provided courtesy of Moy Piano Service, LLC