Back separation

[Mark Dierauf]

>Jeff,
>I'm not sure which issue of the Journal has the topic you inquired about,but,
>you are on the right track re dealing with this problem.
>Yes, let down the tension. Yes, pull the separation together with clamps,
>then secure by drilling out the plate lag bolt holes through the back and
>countersink for the appropriate size nut and washers. Tightbond glue is fine.

Also, bear in mind that the reason that they generally used lag screws instead
of through bolts here  is that the bolts may be prone to loosening during
periods of low humidity - so be sure to check these in the Winter.

            Mark Dierauf