This tip has gotten me out of a few jams. It was taught me by a Swansea tuner. Need a calibrated pin vice in a hurry? The conservative approach. Use a pin a size smaller than the one you are fitting. run it between a couple of files, moving the pin and the 2 files back and forth, till the pin feels rough. You now have a calibrated reamer. Perhaps this should be called the poor man's reamer. I have found this a good technique for a controled reaming of a flange that's too tight on the pin. Regards ----- Henry Brugsch aka hbj elsewhere, CIS: 75366.317@compuserve.com, hbj@bix.com Give me an alias long enough I can mail the world
This PTG archive page provided courtesy of Moy Piano Service, LLC