Circumference is pi x d (or 2 pi r). pi r squared is area. ;-) Alan McCoy ________________________________ From: Paul T Williams <pwilliams4 at unlnotes.unl.edu> Reply-To: CAUTlist <caut at ptg.org> Date: Wed, 23 Jun 2010 12:51:36 -0700 To: CAUTlist <caut at ptg.org> Subject: Re: [CAUT] Damper guide rail holes Jeff, Ken Sloane at Oberlin at the Steinway seminar had us make a new guide rail from scratch two years ago. My project was also a B. We used a #15 drill bit for the main hole, then also put a counter sink hole on both sides for the felt to open up on both sides. We used no glue to install, just pull them through and trim up to look good. Then just used the pi-r-square to figure the radius for cutting the right felt width. I think 5/8" was about right. I think all the Steinway guides have the same damper wire widths. Hope this helps Paul From: Jeff Farris <Jfarris at mail.utexas.edu> To: "caut at ptg.org" <caut at ptg.org> Cc: tseay2 at austin.rr.com Date: 06/23/2010 02:32 PM Subject: [CAUT] Damper guide rail holes ________________________________ Hi List, Anyone know what size drill bit to use for drilling new damper wire guide rail holes for a Steinway B? Or where to find out? Thanks, Jeff Farris Jeff Farris Piano Technician School of Music UT Austin jfarris at mail.utexas.edu <jfarris at mail.utexas.edu> 512-471-0158 -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/caut.php/attachments/20100623/f996ac7b/attachment-0001.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC