On Nov 6, 2008, at 8:49 AM, Mike Kurta wrote: > After replacing over 200 sets of keytops, I have settled on solvent > based contact cement. About contact cement, I have replaced a few sets of keytops that had been glued with contact, and found it VERY difficult to get to clean wood again. The stuff stays gummy and I wasn't able to figure out a solvent that actually did the job. I ended up scraping, wasting sandpaper, and cussing a good deal. Has anyone successfully dealt with this problem? Regards, Fred Sturm University of New Mexico fssturm at unm.edu
This PTG archive page provided courtesy of Moy Piano Service, LLC