[CAUT] New Renner underlever system

[Jim Busby]

List,

When you adjust the springs (for grams) in the Renner underlever system how/where do you take the measurement? I've installed about a dozen of these and realized maybe I haven't been doing it correctly. Here's the dilemma;

Of course the spring increases resistance as you go upwards. When you measure the # 1 lever as it's parallel to the keybed the grams read 30. Lower it slightly below (10 degrees?) parallel and it reads 26. Raise it slightly above level and it's 33. Renner asks for 29 low - 32 high. Is there a "best" way to do this or have I been OK to just do them all at the same place, i.e. parallel, or level to the keybed?

Thanks,
Jim Busby BYU
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/caut.php/attachments/20080506/884c013d/attachment-0001.html