Not at all David. The router is mounted in a router table with a 3/8" straight bit. The key is on its side on top of the jig with notch down. Then you slide the jig over the bit with the straight side of the bit defining the "head" side of the notch and the top of the bit defining the "tail" side of the notch. Once you have set up the jig, about 3-5 minutes, this is foolproof. The only problems you'll have are some minor chipping that can happen (speed and direction of feed are key here as Spurlock discusses in the article). This is truly minor and easily tauched up when doing the final hand filing. Alan > From: David Ilvedson <ilvey@sbcglobal.net> > Reply-To: <ilvey@sbcglobal.net>, "College and University Technicians > <caut@ptg.org>" <caut@ptg.org> > Date: Mon, 18 Apr 2005 10:19:50 -0700 > To: <caut@ptg.org> > Subject: Re: [CAUT] notching > > But isn't the corner of the notch rounded, necessitating squaring with a file? > > David I. > > > > ----- Original message ---------------------------------------- > From: Alan McCoy <amccoy@mail.ewu.edu> > To: College and University Technicians " <caut@ptg.org> <caut@ptg.org> > Received: Mon, 18 Apr 2005 08:45:57 -0700 > Subject: Re: [CAUT] notching > > >> David, > >> I built a router jig, described and designed by Bill Spurlock, for years. >> The notch cuts are never a problem with this jig. Look in the Journal - >> probably late 80's. > > >>> From: David Ilvedson <ilvey@sbcglobal.net> >>> Reply-To: <ilvey@sbcglobal.net>, "College and University Technicians >>> <caut@ptg.org>" <caut@ptg.org> >>> Date: Sat, 16 Apr 2005 15:21:19 -0700 >>> To: <pianotech@ptg.org>, <caut@ptg.org> >>> Subject: [CAUT] notching >>> >>> List, >>> >>> How are you who do keytops making the notch cut? I'm filing by hand at the >>> moment... >>> >>> David I. >>> >>> >>> >>> >>> _______________________________________________ >>> caut list info: https://www.moypiano.com/resources/#archives > > >> _______________________________________________ >> caut list info: https://www.moypiano.com/resources/#archives > > _______________________________________________ > caut list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC