I was going to suggest a collapsible box for hpschd storage. Sounds complicated, but it's not. However, the cover idea could be simpler & much more effective. I would construct a frame over the instrument & make the cover of material which would breath, but slow down the wicking of moisture to the rest of the room -- sort of a tent that could be partially withdrawn for playing. This would allow the humidity access to the whole of the instrument, not just the bottom. Otto ----- Original Message ----- From: "Ron Nossaman" <rnossaman@cox.net> To: "College and University Technicians" <caut@ptg.org> Sent: Tuesday, November 23, 2004 3:55 PM Subject: RE: [CAUT] Damp chaser table > > >Hi David, > > > >The room is about 18x20 with very high ceilings. (Organ pipes and all). > >The HVAC is old and nuts. > > > >I don't really believe the DC will work either, but if we give it a try > >and it doesn't maybe they will go for the room humidifier. The reason they > >didn't already is cost. Smaller units seemed to be too labor intensive > >(fill daily). > > > >Usually harpsichordists tune their own instruments, but here it's always > >been the piano tech's job. The professor is a wonderful man willing let > >the tuning go a bit, but I know there is a way to solve this or make it better. > > > >Jim Busby BYU > > > If you can keep a near floor length cover over the harpsichord, immersing > it in the localized climate, the Dampp-Chaser should help in spite of the > covered bottom. There's just no telling how much. > > Ron N > > _______________________________________________ > caut list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC