Gordon and all- I received the following from Dave Durban; >Date: Tue, 21 Jan 2003 10:23:32 -0800 >From: Dave Durben <ddurben@yamaha.com> >Subject: Re: Removing keybushings >To: davidskolnik@optonline.net >X-Mailer: Novell GroupWise Internet Agent 5.5.6.1 >Original-recipient: rfc822;davidskolnik@optonline.net > >Hello David, > >I got this answer from Greg Frank: > >When the glue won't let go under normal circumstances, it's usually a >synthetic glue. Take a mixture of 1 part ammonia to 3 parts water, and >put just a few drops into the mortise. Then put your bushing iron tip of >your soldering iron into the hole, and turn the key upside down. This >will result in the solution falling onto the hot iron, and shooting into >the felt. Greg tells me that while it is a bit messy, it will blast the >adhesive such that it will let go, and the felt will come out with ease. > >Best regards, > >David Durben >Piano Service Manager >Yamaha Corp. of America >TEL (800) 854-1569 FAX (714) 522-9424 >email: ddurben@yamaha.com >Web: http://www.yamaha.com > > >>> David Skolnik <davidskolnik@optonline.net> 01/16/03 08:37AM >>> >Bill - >I don't know if you, or anyone else at the company monitors the various >piano discussion lists. A question was posed on the College And University >Technicians (CAUT) list today, regarding the best way to remove key >bushings from a Yamaha P22. I've quoted the message below. Would you be >able to address this? A response to the list ( caut@ptg.org ) would be >best. Thanks. > >David Skolnik >davidskolnik@optonline.net > > > > > >Date: Tue, 14 Jan 2003 18:50:13 -0500 (EST) > >From: PNOTNR@aol.com > >Subject: Yamaha key bushings (ideas how to remove) > >Sender: caut-bounces@ptg.org > >To: caut@ptg.org > >Reply-to: College and University Technicians <caut@ptg.org> > >X-Mailer: AOL 8.0 for Windows US sub 230 > >X-BeenThere: caut@ptg.org > >Original-recipient: rfc822;davidskolnik@optonline.net > > > >I have a set of keys (out of a P-22 from one of the practice rooms) in for > >key bushings. My usual method of steaming the old bushings out doesn't > >seem to do much. > > > >Can someone tell me what glue was used to put the original bushings > >in. (and what an appropriate solvent would be.) I've tried steam > >(ironing a damp cloth strip over the bushings), wallpaper remover > >pre-soak, and just plain picking at them. Thanks for any help. > > > >Gordon Large, RPT > >(Colby College, Waterville, ME)
This PTG archive page provided courtesy of Moy Piano Service, LLC