[pianotech] Worst Bass/Tenor Crossover in Universe

Delwin D Fandrich del at fandrichpiano.com
Tue Jan 8 12:03:48 MST 2013


1)  The only place where panel cracks are a concern are in those limited
areas where the grain angle of the panel roughly parallels the inner rim. In
most pianos this condition is only found on the inside curve of rim on the
treble side. And sometimes along a soundboard cutoff bar. Other than these
two areas there is no need to set the ends of the ribs into rim notches
unless your intent is to stiffen the assembly. 

2)  No bridge termination system is "designed to be used at zero bearing."
The termination system doesn't really care whether there is string bearing
or not. String bearing has to do with the physical interaction between the
vibrating strings and the resulting motion of the soundboard assembly. 

Cantilevered bass bridges have long been set up with "zero bearing." Fifty
years ago old-timers were warning us young whipper-snappers of the dangers
of putting any string bearing on cantilevered bass bridges. Even if you were
to load up a cantilevered bass bridge with a bunch of string bearing it
wouldn't last long; the thing just rotates and the soundboard assembly just
distorts and it all goes away.

Delwin D Fandrich
Piano Design & Fabrication
6939 Foothill Court SW, Olympia, Washington 98512 USA
Phone  360.515.0119 — Cell  360.388.6525
del at fandrichpiano.comddfandrich at gmail.com


-----Original Message-----
From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf
Of Jim Ialeggio
Sent: Tuesday, January 08, 2013 9:56 AM
To: pianotech at ptg.org
Subject: [pianotech] Worst Bass/Tenor Crossover in Universe


... I am also edging closer to selectively bagging rim notches in cross
grain areas where stiffness is required(ribs), but freedom of movement is
desirable. (but still a bit concerned about panel cracks at the rim
joint)

Also, there might be a completely different approach. Since the Phoenix
agraffes are designed to be used at zero bearing, the zero bearing could
conceivably allow a high bass cantilever without the roll
tendency???maybe??? Though in a sh-t box like Terry's victim, the point is
largely hypothetical.

Jim Ialeggio




More information about the pianotech mailing list

This PTG archive page provided courtesy of Moy Piano Service, LLC