On 1/4/2013 11:43 PM, Dean May wrote: > I had to replace hammer spring cords on a Yamaha U1 and it did not have > the butt plates holding the hammers to center pin, so I was unable to > use Jon Page’s protocol. Instead, after fighting with a few, I made this > simple fixture and share for your amusement and so Joe the Tool Captain > can tell me how I did it wrong. (just kidding, Joe) Dean, There are boxes, but no photos. The post is only 11.5K, so the photos apparently didn't come with the post. ???? Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC