Wrong! Loosen the damper rail blocks from the belly rail. Tilt the whole thing out and then tighten the flange screws. -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of tnrwim at aol.com Sent: Wednesday, October 10, 2012 8:45 PM To: pianotech at ptg.org Subject: Re: [pianotech] Damper Lift Rail Flange Screw Access The best way to get to those screws is to remove all the dampers, which allows you to lift the tray which gives you access to the screws Wim Sent from my iPhone On Oct 10, 2012, at 2:31 PM, Terry Farrell <mfarrel2 at tampabay.rr.com> wrote: > Is there any better way to remove/install screws on an Korean piano's damper lift rail flange screws other than go at them at an inefficient angle? Is there some tool that I'm obviously not aware of that makes getting in there a piece of cake? > > Thanks! > > Terry Farrell > > <IMG_0285.jpg>
This PTG archive page provided courtesy of Moy Piano Service, LLC