Terry, Is that a good "Grrrrrrrrrrrrrrrrrrrrrrrrrrr",or is that an angry "Grrrrrrrrrrrrrrrrr"? Joe > [Original Message] > From: Terry Farrell <mfarrel2 at tampabay.rr.com> > To: <joegarrett at earthlink.net>; <pianotech at ptg.org> > Date: 10/10/2012 6:07:33 PM > Subject: Re: [pianotech] Damper Lift Rail Flange Screw Access > > Grrrrrrrrrrrrrrrrrrrrrrrrrrrrrrr. > > On Oct 10, 2012, at 8:42 PM, Joseph Garrett wrote: > > > Terry The Farrell said: > > "Is there any better way to remove/install screws on an Korean piano's > > damper lift rail flange screws other than go at them at an inefficient > > angle? Is there some tool that I'm obviously not aware of that makes > > getting in there a piece of cake?" > > Thanks! > > > > Terry, > > Hmmm? I'd use either a stubby screw driver or an offset screwdriver, > > (ratchet type, made by General), to remove the Vertical Screw first.Then > > lift the lever and straight access to the horizontal one.<G> > > Joe > > > > > > Joe Garrett, R.P.T. > > Captain of the Tool Police > > Squares R I > >
This PTG archive page provided courtesy of Moy Piano Service, LLC