Asked Glen @ Satellite City. Flammability not a hazard. >Good, Different, not better. I looked at MSDS from Satellite City >http://www.caglue.com/assets/msds/UFO%20Thin%20MSDS.pdf >but am not sure what it means, so I (or you) can call them after 9:00AM PST >(800) 786-0062 > >David Skolnik >Hastings on Hudson, NY > >At 10:55 AM 2/23/2012, you wrote: >>Maybe an even better question is whether the fan has to be rated combustion >>proof. >> >>Greg Newell >> >>-----Original Message----- >>From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf >>Of David Skolnik >>Sent: Thursday, February 23, 2012 9:48 AM >>To: pianotech at ptg.org >>Subject: Re: [pianotech] CA fume fan >> >>Rex - >>I stopped by a good, local hardware store last week to get a sense of cost >>and availability of parts. I realized that there were some aspects of this >>set up I didn't quite understand, one being the scale: >>If the fan is 8", what are the dimensions of the floor vent? >>Is the fan housing what is visible in the photo, or has the fan been >>inserted into a length of duct? >>With the fan you used, what do you think the maximum effective length of 4" >>hose would be? >>Was this constructed with standard pop rivets? >>Are there better grades of duct work? The ones I found seemed pretty >>flimsy. >>If remote location is not possible, how would you rate the noise of the fan >>you used? >> >>Thanks. Still optimistic. >> >>David Skolnik >>Hastings on Hudson, NY >
This PTG archive page provided courtesy of Moy Piano Service, LLC