Good suggestions so far. Be careful about longer, or fatter, screws. I've had the finish bubble from the pressure of new screws. Many times the screws are angled toward the surface. Paul McCloud San Diego ----- Original Message ----- From: paulmulik at yahoo.com To: pianotech at ptg.org Sent: Thursday, December 20, 2012 5:16:54 AM Subject: [pianotech] Filling screw holes A school that I tune for has a Kawai grand, and about a third of the little screws from the long hinge (connecting the front lid to the main lid) have fallen out. I've told them repeatedly that if they need to move the piano around the room they must not push on the lid (I even left a note to the lid warning against it), and of course they have ignored this advice. In the past I tried replacing them with slightly longer screws but those have fallen out too. Obviously I need to fill the holes with something, I guess using a syringe, but what? Epoxy? Wood filler? Thick CA? Thanks, Paul Mulik Sent from my U.S. Cellular BlackBerry® smartphone
This PTG archive page provided courtesy of Moy Piano Service, LLC