What is the size of the screws that goes in brass flanges? When the brass plate breaks the screw does not fit the replacement plate, from Schaff. The screw that is supplied with the new plate is too long, and the round head isn't right. What tap do I need? I seem to have trouble trying to figure out the size. John Ross Windsor, Nova Scotia On 17-08-2012, at 12:39 AM, Ron Nossaman <rnossaman at cox.net> wrote: > > Tool geeks, > Doing some hardware prospecting, I came across this. > > > http://www.victornet.com/store/Special-Pitch-Taps-up-to-1/2/1260.html > > If you ever need a tap size that doesn't exist, these guys probably already have one in stock. Look around the site with your wish list. You can likely fill the order in one stop. Decent prices too. > > PS: how do I always end up with five 1/4"-20 taps and no 1/4-28 when that's what I need? Grrrr....... > > Ron N -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20120817/b40761eb/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC