Yes, but only in the staple area and I do not let itcreep higher than about 8:30 and 3:30. FWIW I treat all Hammers this way as do some European makers (ie. Steingraebber) Capishe? Dale Dale Erwin RPT- Mason & Hamlin/Steinway/U.S pianos Pre-hung Ronsen hammer sets/Abel parts Sitka Soundboards & Supplies WWW.Erwinspiano.com 209-577-8397 -----Original Message----- From: jim <jim at grandpianosolutions.com> To: pianotech <pianotech at ptg.org> Sent: Thu, Apr 12, 2012 7:59 am Subject: Re: [pianotech] Hammer stapling-tone builders corner One rarely notices any tonal effect from this application in and of itself but I notice a solidifying affect in the tone of the Weickert felt hammers quite dramatically...and that was from the very first set I applied this protocol to. Dale Just to be clear, you are applying low shoulder dope to the Weikerts, with good effect...is that correct? Jim I -- Jim Ialeggio jim at grandpianosolutions.com (978) 425-9026 Shirley, MA -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20120412/5b38fadf/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC