[pianotech] Bridge marking tool

[Encore Pianos]

Why thank you very much, David.  I'll use that next week on my B as I am
setting bearing.

Will Truitt

-----Original Message-----
From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf
Of David Love
Sent: Friday, October 14, 2011 4:57 PM
To: pianotech at ptg.org
Subject: [pianotech] Bridge marking tool

I used to use the one on the right (first photo) but screwing it down to
expand the rubber washer to get it to hold was a lot of trouble and time.
The one on the left is much easier.  1/4" dowel, tuning pin bushing, thread.


David Love
www.davidlovepianos.com