At 00:09 -0400 30/09/2010, Dale Erwin wrote:
>Ok, I don't know where this info comes from but having my hands on a
>Dolge type screw press and having participated in operating it makes
>me question the numbers below as truly possible. Ok, maybe a mute
>point
Hello Dale,
The info comes from the horse's mouth -- Alfred Dolge.
By the time he published his book in 1911 he had long got rid of his
screw presses and was using pneumatic machines.
>>At Dolge's factory, working with animal glue, about 1910 he
>>estimated that two expert gluers working on a single machine were
>>able to cover 240 sets in 10 hours. This was achieved, on his
>>latest machines, but also on earlier machines by other makers in
>>Europe by using removable cauls.
> Ok, lets think this thru. First cutting felt strips and preparing
>them for gluing would take at least a couple days. Takes a skilled
>hand and an sharp knife. And 24 sets per hour for ten hours doesn't
>seem real to me.
If you read my quote, or even better read his book -- I'm surprised
you haven't -- you will see he is talking of the men at the machine,
the gluers. He obviously is not talking of the total time taken to
make and cut up the mouldings and the time taken to cut the felt.
The gluers are working with a pile of felt strips and a rotating
stock of removable caul/clamp units. I presume also that the
mouldings are already clamped by another less skilled workman. The
whole point, and what we are discussing here, is machine time.
>>If Dolge's men (and no doubt others, using different machines) were
>>able to press hammers at a rate of one set per three minutes
>>without using heated cauls, I suggest that, as in so many other
>>instances in our trade, a great deal of good sense and invention
>>has simply been lost over the years.
> No doubt but the numbers seem impossible without more hands in
>this operation. No what I mean?
The subject of the thread is "cold pressed hammers" and the purpose
of my response was to point out that the overheating of hammer-heads
in order to speed up the setting of the glue is quite unnnecessary
when removable clamping assemblies are used, as they were widely
before the first world war, and not only by Dolge, whose word I have
no reason to doubt.
JD
--
______________________________________________________________________
Delacour Pianos * Silo * Deverel Farm * Milborne St. Andrew
Dorset DT11 0HX * England
Phone: +44 1202 731 031
Mobile: +44 7801 310 689
______________________________________________________________________
This PTG archive page provided courtesy of Moy Piano Service, LLC