I only use the Tormek system when I want to remove a fair amount of material. The water bath keeps the edge cool protecting the temper, but the edge it leaves is too rough. So I change to a Veritas honing guide, set for a slightly steeper angle. The guide permits flattening the back as well as the bevel. Final edge dressing is with a light touch of a burnisher. Tom Cole On 10/10/10 8:01 AM, David Love wrote: > > I'm curious about those who use the Tormek system, how do you go about > flattening the back of the chisel? > > David Love > > www.davidlovepianos.com > > *From:* pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] > *On Behalf Of *Thomas Cole > *Sent:* Saturday, October 09, 2010 10:44 PM > *To:* pianotech at ptg.org > *Subject:* Re: [pianotech] Of Chisels > > Another thing I like doing is to square up the blade and at the same > time remove any nicks in the edge (see photo). > > The Tormek system is great for recreating the bevel, but be careful > you don't grind at a very low angle on Japanese chisels due to the > brittleness of the high-carbon steel. > > Tom Cole > > William Truitt wrote: > > And, as you know Jim, you have to flatten the back on the chisel > before you can begin to sharpen it. Which is why the backs of these > chisel has one or more reliefs, which allows you to bring it to a > flattened state much more quickly. > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20101010/e41db9cd/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC