You know, those three steel bars with hooks attached that fit over the rest rail. Rick Ucci/ Ucci Piano www.uccipiano.com On Jun 28, 2010, at 4:11 PM, "Tom Driscoll" <tomtuner at verizon.net> wrote: > Rick, > What is "The bars with the hooks" ? > > Looks like a Baldwin. Disconnect the stickers from the keys by > popping the grommets off the forks. Remove the keys as the wires can > hang up in the forks as you lift out the action. Then remove the > screws that are threaded into the plate at the top of the action > bracket. Some of these have screws under the keybed into a rail and > some mount on a stud. . Either way lift the sucker out. > After you replace the grommets that crumble on step one you may have > to lower the action supports to line the top of the brackets with > the threaded holes in the plate in order to get the thing back in. > Have fun and check for the Corfam problem whilst you're at it. > Tom Driscoll > > > ----- Original Message ----- From: "Richard Ucci" Subject: > [pianotech] Removal > > >> List, what would be the best way to remove this action? >> I have the bars with the hooks but not sure the will work properly. >> >> > >
This PTG archive page provided courtesy of Moy Piano Service, LLC