Dale, Quick question about finishing. You spray lacquer on the board and rub out? Do you mask the case, or are you spraying both simultaneously? thanks Mike erwinspiano at aol.com wrote: > Hi > * Last week there was a discussion about spruce quality,color,grain > count etc. A few asked off list to see one of the panels I referred > to. The one pictured was just glued in yesterday & has it's final > gloss coats of lacquer applied. Rub out Manana. This board was made > from some to the really wide reddish planks with a grain count of > roughly 22 grains an inch. The two planks in the middle are 9 & 11 > inches wide make up at least half the entire panel. > It's much prettier now that is under clear gloss lacquer. The reddish > color is diminished. The grain really pops and hopefully the tone will > as well. I'll post the other requested pics of the other panels glued > up recently. My Batteries died in the cameras. There always doing that. > Dale* > > ------------------------------------------------------------------------ > Live traffic, local info, maps, directions and more with the NEW > MapQuest Toolbar. Get it now > <http://www.mapquest.com/toolbar?ncid=emlwemqmq00000003>! > > ------------------------------------------------------------------------ >
This PTG archive page provided courtesy of Moy Piano Service, LLC