Hi Mike, the shelf can be adjusted up and down and pitch also. Sent from my iPhone On Jul 14, 2009, at 1:55 PM, Michael Magness <IFixPianos at yahoo.com> wrote: > > > On Tue, Jul 14, 2009 at 12:45 PM, Richard <richard.ucci at att.net> > wrote: > List, > My first hammer hang with jig, do the hammer shanks need to be level > or can the shelf be angled ? > > Sent from my iPhone > > > Hi Richard, > > I have that jig, the shanks should be level which usually happens > "automatically" if the hammers were bored correctly. The shelf the > tails rest on, if I'm not mistaken, is fixed and can't be angled. > The only shelf that can be "angled" is the hammer alignment shelf > which should be set to samples, I use the end hammers of the old set > and if the section is a long one, I'll leave one in the center as > well. > > Good luck, > > Mike > > -- > I intend to live forever. So far, so good. > Steven Wright > > > Michael Magness > Magness Piano Service > 608-786-4404 > www.IFixPianos.com > email mike at ifixpianos.com -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20090714/d4488700/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC