Wim writes:
<< Personally, I reverse the pin at least 3 full turns, and then, using a
pair of needle nose pliers, guide the string into the hole of the pin, >>
I recommend against this protocol. Turning in and out three turns
will reduce the pin torque, (I have measured a drop from 130 in/lbs to 110
in a 10 year old Yamaha, and a drop from 100 in/lbs to 80 in a 40 year old
Baldwin). Perhaps a Falconwood or Delignit block will withstand it better,
but there is no need to put this much wear on the block. If the piano is in a
high usage situation, and you have to replace the string twice, you will
certainly create a torque problem.
I turn the pin out 3/4 turn, only. For me, using a dummy pin is
faster, gives a better coil, reduces block degradation, and makes it easier to
keep the pin at the original, finished height.
Regards,
Ed Foote RPT
http://www.uk-piano.org/edfoote/index.html
www.uk-piano.org/edfoote/well_tempered_piano.html
<BR><BR><BR>**************<BR>Looking for love this summer? Find it now on
AOL Personals. (http://personals.aol.com/?ncid=emlcntuslove00000003)</HTML>
This PTG archive page provided courtesy of Moy Piano Service, LLC