Thumpe, Once you do get the old ones off, you can buy very nice new ones from Pianotec. Fenton ----- Original Message ----- From: "Joe And Penny Goss" <imatunr at srvinet.com> To: <lclgcnp at yahoo.com>; <pianotech at ptg.org> Sent: Monday, February 02, 2009 8:04 AM Subject: Re: [pianotech] Is there a tool for the dented nuts on plate noseboltsin old Knabe upright? > Hi Thumpe, > Easy to make one. What is the width of the slot? n_n the distance > between > the two n's > Piece of old strap iron > Joe Goss RPT > Mother Goose Tools > imatunr at srvinet.com > www.mothergoosetools.com > ----- Original Message ----- > From: "Euphonious Thumpe" <lclgcnp at yahoo.com> > To: <pianotech at ptg.org> > Sent: Monday, February 02, 2009 8:16 AM > Subject: [pianotech] Is there a tool for the dented nuts on plate nose > boltsin old Knabe upright? > > >> Dear everyone, >> Dismantling a 1919 Knabe Ampico upright, yesterday, got to those > annoying brass nuts on the plate-strut nose bolts that have the two > opposed > notches. Does someone currently sell a tool for this. ( And, no, I'd > prefer > the answer not be "Vise-Grips(TM) ) >> >> Euphonious Thumpe >> >> >> >> >> >> >> > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC