Hi,Dave !! I would reccomend installing the TWIN DOLLIES,as well. I had installed many sets,at the last convention I was able to prove to the class that they can be installed in less then 26 minutes ,including demo,talking,joking,etc......Good luck....isaac On Aug 24, 2009, at 7:37 PM, Claude Harding wrote: > > David, > If you want to put on the Darnell 2" casters, I think you may be > stuck with > the "chisel & shim" you spoke of. > I am answering your question to ask if installing the twin piano > dollies > would be an option in your situation. Not quite as neat in > appearance when > you are through, but quite functional and maybe less hassle than > changing > the design of the casters on the piano. Just wondering. > Good luck. > Claude Harding > P.S. Hurry and send in your registration for the SCRC Seminar. > Houston is > an easy drive from New Orleans. :-) <www.ptg.org/scrc> > > -----Original Message----- > From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] > On Behalf > Of David Doremus > Sent: Monday, August 24, 2009 8:36 PM > To: pianotech at ptg.org > Subject: [pianotech] Yamaha U1 casters > > Does anyone have a standard procedure for replacing these? They are > small > diameter (roughly 1 1/4"), the front ones are taller overall, are > recessed > into the leg and have no stem to speak of, the rear pair are shorter > but are > not recessed, and do have a stem. This one wants to roll easily in a > school > room so I want to put on the 2" rubber darnell casters and guess > I'll just > have to chisel and shim until I get them level. As usual what looked > like a > simple task is needlessly complicated. If anyone has experience they > want to > share I'd appreciate it. > > --Dave > New Orleans > >
This PTG archive page provided courtesy of Moy Piano Service, LLC