There seems to be a lot of confusing talk in the piano tech world about "key inertia". I was confused, too, until I went back to my physics textbook and found: Inertia by definition means resistance to acceleration, and (at speeds lower than the speed of light or so) inertia and mass are identical. And weight is proportional to mass on the surface of a particular planet. In summary: Two items of the same weight have the same inertia here on Earth. Period. If a perfectly rigid key weighed 1000 pounds overall but were balanced to have a certain down-weight, it would behave and feel the same as any other rigid key with the same down-weight. But we all know that a key with less weight in front has more dynamic range. The key, pardon the pun, is the rigidity. When I press a key I am wasting energy for a very small amount of time when I am overcoming the weight (i.e. inertia) in the front of the key because it bends. There would be less wasteful bending and more dynamic range if there were less weight in front. Correct me if I'm wrong here, but I think the concept is as simple as that. No need to fabricate a giant experimental contraption and write a multi-part journal article about it. Another aspect of this is time: the weight can change over the duration of the key press. This is why damper regulation can be important. But, again, a simple concept. I think a lot of us are confused about this stuff when we don't really need to be. The hard part is figuring out how to engineer a key to behave at its best.
This PTG archive page provided courtesy of Moy Piano Service, LLC