Yes, exactly. It's on the high side of 2mm thick. Alcohol-water size with #7 (.086) bridge pins after installation. Mike William Monroe wrote: > Mike, > > Am I to understand that you use just the white action cloth and no > second layer? Just find the thickness that works? > > Thanks, > William R. Monroe > > > >> We usually end up using Pianotek's white action cloth - I forget >> which thickness it is, but way easier than laminating layers of >> bushing cloth. >> >> Mike >> >> Stephen Grattan wrote: >>> If for some reason the thickest bushing cloth is still too thin, >>> laminate the two thicknesses you would need together. Use a spray >>> contact cement on both pieces, let dry the prescribed time and press >>> together. The contact cement will not wick through as would hide >>> glue and it remains flexible. Be sure the grain runs the same >>> direction so you can tear the strips. I have done this several times >>> with no problems. >>> *Steve Grattan* >>> *Lost Chord Clinic* > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC