[pianotech] S&S Hammer rail question

[Tom Driscoll]

Mr. B.
    The late great Don Galt suggested inserting two thin strips of leather 
with tightbond. Then screw in the screw without the flange. When dry remove 
the screw,trim the leather flush and done. For one or a few this seems to 
make sense .
    Tom --Waiting for spring training==Driscoll
----- Original Message ----- 
From: "Phil Bondi" <phil at philbondi.com>
To: "Newtonville" <pianotech at ptg.org>
Sent: Tuesday, November 25, 2008 7:24 PM
Subject: [pianotech] S&S Hammer rail question


> I'm replacing Hammers, shanks, flanges on a D, and I noticed
> that 1 of the screws on the hammer rail is stripped.
>
> Is there a recommended best fix for this?
>
> Thanks,
>
> -Phil Bondi(Fl)
>


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.175 / Virus Database: 270.9.10/1811 - Release Date: 11/25/2008 
8:29 AM