[pianotech] Downbearing

[John Ross]

It must depend on where you are, as I have had no problem with re-pinning an upright pinblock.
If it is just loose pins, then yes C/A is the way to go.
John Ross
  ----- Original Message ----- 
  From: Dean May 
  To: pianotech at ptg.org 
  Sent: Friday, November 21, 2008 6:37 PM
  Subject: Re: [pianotech] Spam: Downbearing


  I'd urge you to rethink the  pinblock. Use pin block plugs from Web Phillips. Very easy. The odds are not good that re-pinning an old upright will hold. And if it doesn't your reputation is tarnished as a result. If you do choose to repin only, add 2-3 drops of thin CA glue into the holes before inserting the new pins. It will dramatically improve their gripping power. 

   

  Dean

   

  Dean May             cell 812.239.3359 

  PianoRebuilders.com   812.235.5272 

  Terre Haute IN  47802

   


------------------------------------------------------------------------------

  From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Noah Haverkamp
  Sent: Friday, November 21, 2008 3:30 PM
  To: pianotech at ptg.org
  Subject: Spam: [pianotech] Downbearing

   

        I am coming up on my first rebuild/restoration. Probably won't install new pinblock, but I am interested in measuring Downbearing, not only on this upright but also in general. It seems like an interesting thing at the moment. I've read through Reblitz' method using the string, but would like to maybe buy the Lowell Gauge or the generic dial gauge Schaff sells. Any comments/suggestions? I like the way the dial gauge looks. 

        Noah Haverkamp Frere
        Know-a Piano? 
        http://www.knowapiano.com 
        347-308-0094 
       

   

John M.Ross
Windsor, Nova Scotia, Canada.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20081121/114454ea/attachment.html>