Keyframe Bedding

[Jon Page]

>I'm a little confused by the dimensions you give. You set the caliper for
>.015 to .020 clearance, turn bolts up until the keys touch. Then you say
>.010 is sufficient. Do you go for a range of .010 to .020?

Depending on the length of the key, you get differing key height effect from
stressing the frame. Start conservatively with .010".  Apply lift and 
tap the rail,
if knocking persists turn the bolt a little more then check your height for the
amount to set the next one, it might go to .010 or .020 +.   It was on the ends
of this key frame that it could only take a .010" rise as a little more and the
front rail knocked.
-- 

Regards,

Jon Page
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20080707/45824c19/attachment-0001.html