HI Jim Yeah, it's a synch. I use brad points that just fits in the holes. I dimple each pin location & then drill with a brad point on the drill press. Hles vary & so do the brad point sizes. The brad point just homes in on that little target & bulls eye. Dale >I also have a very accurate way of determining the >plate hole center which I like & so I >probably won't switch any time soon. > Dale Could you describe that proceedure? Jim ************************************** See what's new at http://www.aol.com -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20071001/b8dfad38/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC