Slightly flatten the cutting edge of the bit on your grinder. It will drill out cast iron quite well without grabbing. A.L. On 3/2/07, Ron Nossaman <rnossaman at cox.net> wrote: > > > > You mentioned that sometimes screws don't line up with backposts. I > > don't have a problem drilling a hole in the plate so there *is* a bolt > > going through all/most of the backposts. > > > > Dave Davis, RPT > > > I have a problem with it. It's hard on the wrist when the > drill breaks through the iron and grabs! > Ron N > -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070304/417c4c40/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC