I had used the combinations many times dating to the late 1960's. I have found no residual problems at all. James James Grebe Piano Tuning & Repair Member of Master Piano Technicians. Registered Piano Technician of the Piano Technicians Guild for over 30 years. "Member of the Year" in 1989 Creator of Handsome Hardwood Caster Cups, Piano Benches, Music Cabinets, Writing Instruments,Table Timepieces (314) 608-4137 1526 Raspberry Lane Arnold, MO 63010 Researcher of St. Louis Theatre History BECOME WHAT YOU BELIEVE! pianoman at accessus.net Jimpianowood at yahoo.com ----- Original Message ----- From: "Joel A. Jones" <jajones2 at wisc.edu> To: "Pianotech List" <pianotech at ptg.org> Sent: Thursday, July 19, 2007 8:01 AM Subject: wurly juice (wantin,,) > list, > This thread sets off my memory searching for the mixture of silicone and > xxxxx that the Wurlitzer service dept. poured on the actions for lube. > The > silicone came in a can and there was a recipe for mixing in other > ingredients > for this lube. I can see the service team pouring it out of a squeeze > bottle > with the action out of the piano setting on it's side. We pour it on.... > > What I'm wondering about this situation is the residual effects of the > Wurly Juice formula and whether it is causing the gunk in the bushing > at this time. > > Any memories of this treatment ? > > Joel > > Joel Jones, RPT > Madison, WI > > On Jul 19, 2007, at 7:03 AM, John Formsma wrote: > >> I also find lots of Wurlies with tight wippen centers. We're talking >> 8-10 grams at least, and gunk in the bushing. >> >> Have tried alcohol/water, which has not worked so well, but it does on >> a few such wippens. Protek/Goose Juice might work on some that don't >> have that much friction. Repinning is the guaranteed solution, and >> you'll be getting pretty good by the end of that job. ;-) >> >> JF >> >> On 7/19/07, Dean May <deanmay at pianorebuilders.com> wrote: >>> >>> >>> >>> >>> Hey Steven >>> >>> >>> >>> I usually try the Protek or Goose Juice first. It's easy and I keep a >>> hypo >>> oiler of it right in my tool kit. >>> >>> >>> >>> A used Wurly console, eh? They can be troublesome. I've had several of >>> those >>> where the problem was too much friction in the whippen pin. Some >>> responded >>> to Protek, some needed repining. >>> >>> >>> >>> Note which keys are particularly troublesome. Take the action out, >>> remove >>> that whippen, and test the flange for tightness. Apply Protek and see if >>> it >>> frees up. If it works, go ahead and lubricate all of them. Just turn the >>> action upside down and squirt along the whippen pin joints. >>> >>> >>> >>> If it doesn't free up I'm afraid you'll have to do some re-pinning. >>> Although >>> you might try alcohol treatment first. I've never done it, but others >>> have >>> good success. Search the archives. >>> >>> >>> >>> Lay the action on the dampers and then lube all of the jack flanges. >>> Finally, do the hammer flanges. >>> --------------------------- >>> >>> Dean >>> >>> Dean May cell 812.239.3359 >>> >>> PianoRebuilders.com 812.235.5272 >>> >>> Terre Haute IN 47802 >>> >>> ________________________________ >>> >>> >>> From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On >>> Behalf >>> Of Steven Hopp >>> Sent: Wednesday, July 18, 2007 11:52 PM >>> To: pianotech at ptg.org >>> Subject: RE: Wanting to do it right >>> ---------------------------------------------- >>> >>> When might a lubricant i.e. >>> protech be used vs. re=pining? Would your advice for the key culprit be >>> any >>> different knowing the piano was used? Again Thanks >>> >>> Steven >>> >>> >> > >
This PTG archive page provided courtesy of Moy Piano Service, LLC