Plastic Flanges, Repair or Replace?

PAULREVENKOJONES paulrevenkojones at aol.com
Mon Aug 13 21:18:28 MDT 2007


Don Mannino would tell you, I think, that there is plenty of "give" in this material. I have pushed a number 25 (60 mils) pin through one and it works just fine. Don?

Paul

"If you want to know the truth, stop having opinions" (Chinese fortune cookie)


In a message dated 08/13/07 20:46:33 Central Daylight Time, jrpiano at win.eastlink.ca writes:
I am obviously not up with the composition, of the different 'plastics'. I still look at them as 'plastic' regardless of what the really are.
I wasn't meaning the bushing as not being able to be reamed, I was wondering if the, what I now know is Styran, would have enough 'give' for the larger pin, or would it split.
And yes, I did have a spare, and replaced it.
John M. Ross
Windsor, Nova Scotia, Canada
jrpiano at win.eastlink.ca
----- Original Message ----- 
From: Michael Magness 
To: Pianotech List 
Sent: Monday, August 13, 2007 9:21 PM
Subject: Re: Plastic Flanges, Repair or Replace?


I have to assume since you say the piano is only 10 years old that it is a Kawai? What you are working with ISN'T plastic, plastics are petroleum based and were tried in pianos years ago and were an abysmal failure! 

Kawai uses Styran, a rubber based man made material that has been a wonderfull success for them. The glue to rebush would be the PVC glue, the same glue you use to glue keytops to wood. I have not experienced loose pins just the occasional tight one. I don't understand not reaming for a larger pin unless the felt was worn through to the styran? 

My understanding is the flanges are cheaper to produce yet have closer tolerances and are impervious to humidity. My point being, perhaps keeping a small supply of them on hand and tossing them, rather than rebushing them might be more economical. At some point you need to look at cost vs. time spent doing the repair of a readily available, fairly economical item. 

One other point, do not under any circumstances use the alcohol & water treatment on the styran flanges if you feel they are too tight. The alcohol makes the styran brittle and will ruin it. If you have a few just re-pin if you have many use Naptha& water in a 50/50 mix. 

 
Michael Magness
Magness Piano Service
608-786-4404
www.IFixPianos.com
email mike at ifixpianos.com 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20070813/58a35498/attachment.html 


More information about the Pianotech mailing list

This PTG archive page provided courtesy of Moy Piano Service, LLC