composite block warping

[Bob Hull]

Hi Ron, 
--- Ron Nossaman <rnossaman at cox.net> wrote:


> That SD-10 was drilled at 6.8mm, with 2/0 x 2 3/8"
> pins, and 
> was very characteristic of how my blocks feel. What
> did you 
> think of that one?
> 
  The block was tighter than most new blocks I
encounter but not jumpy or overtight.  It was not hard
to control the movement of the pin.  I liked it.

Do you exercise some humidity control on your blocks
right up to drilling time?  

Bob 





       
____________________________________________________________________________________
Sick sense of humor? Visit Yahoo! TV's 
Comedy with an Edge to see what's on, when. 
http://tv.yahoo.com/collections/222