Greetings,
If I finally pick a tuning and proceed, do I tune to A440? The
Rollingball website .gif charts illistrate the temperament intervals from C to C.
Do I start on middle C? If so, middle C of 523Hz (as in an A-440 tuning), or
would I tune middle C lower? Can I still tune an F to F procedure as I am
used to for ET?
Also, what does it mean on the side of the Rollingball chart where
it states the following sentence: "To zero out total tension change, add this
to each offset"....then it gives a number, for example the Valotti has a
-1.96 below that sentence.
Also, on the Rollingball chart, the low C-G and E-G is different bps
than octave above it. Must I follow that difference through with all the
octaves C# to C#, D to D...etc, thereby giving a "stretch" to the whole piano's
tuning? if that answer is yes then the whole piano is a temperament itself, and
I am not copying octaves as I would do in ET!!!???? Right? Are these
temperaments stretched. Woah! I have never done this before.
Julia Gottshall
Reading, PA
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060918/27ee2f19/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC