clamped in > a > drill press vise. Drill them out. Once you have created your jig, this is > faster than fiddling with pulling out the old shanks. Glad that someone said it at last!!! Ive done it that way before (on a set of Rönish butts with some sort of "impossible to melt" glue) and it is fast, accurate and quite fun! Patrick > Ed, > > I agree that replacing is cheaper and will give better results. However if > you are determined to replace the shanks just cut them off flush with the > butt. Create a jig to hold the butts. The jig and butt then are clamped in > a > drill press vise. Drill them out. Once you have created your jig, this is > faster than fiddling with pulling out the old shanks. > > Alan > > --Alan McCoy, RPT > Inland Northwest Chapter > Spokane, WA > ahm at webband.com > > -----Original Message----- > From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On > Behalf > Of ed miller > Sent: Saturday, October 21, 2006 7:43 AM > To: pianotech at ptg.org > Subject: removing shanks from butts > > List, > > I am about to rebuild a set of hammer butts, and put in new shanks and > hammers. However, I can't get these pesky shanks out of the butts. I have > done everything I've learned..... breaking away the collar, soaking the > shank/butt joint with wallpaper remover, even applying some steam to help > loosen the glue (it is hot hide glue). > > I've only tried it on shanks that have hammers already broken off. So I've > been using a shank clamp as the end point for the shank/butt remover to > push > against. The clamp keeps sliding up the shank before the shank/butt joint > will break loose (and I've tightened it really hard, to the point where > the > shank is pretty smooshed). > > Does anyone have any suggestions? > > Thanks, > Ed > > _________________________________________________________________ > Stay in touch with old friends and meet new ones with Windows Live Spaces > http://clk.atdmt.com/MSN/go/msnnkwsp0070000001msn/direct/01/?href=http://spa > ces.live.com/spacesapi.aspx?wx_action=create&wx_url=/friends.aspx&mkt=en-us > > Patrick Hinves Ballesta Afinador/Técnico 610442371 PIANISSIMO PIANOFORTE S.L.
This PTG archive page provided courtesy of Moy Piano Service, LLC