Hi, Scott. DAG (Denatured Alcohol and Graphite). Usually applied, let dry, and burnished (bridge tops, top of jacks, etc. Clark A. Sprague, RPT ----- Original Message ----- From: "Scott Jackson" <scott at pianos.net.au> To: "Pianotech List" <pianotech at ptg.org> Sent: Tuesday, November 14, 2006 7:26 AM Subject: Re: applying graphite >I thought that "Dag" was the gunky graphite grease? > > Scott Jackson > > >> Unfortunately, a lot of techs confuse dry graphite powder with the gunky >> "graphite grease" that was used in past decades by several manufacturers >> who smeared it all over repetition spring grooves in grands especially, >> but also on trapwork springs and elsewhere. Because of this gunk, >> graphite in any form has gotten a bad rep. >>-------------------snip-------------------< >> For tops of dowel capstans, jacks, tops of repetition levers, etc., I >> used to use Dag, and sometimes still do, but prefer Emralon. >> --David Nereson, RPT >
This PTG archive page provided courtesy of Moy Piano Service, LLC