Bob- One solution could be to drill out the holes in the web to the size needed for standard tuning pin bushings. I can supply smaller bushings - they are 10 mm (.394"). (Perhaps too small for your piano...) Jurgen Goering Piano Forte Supply (250) 754-2440 info at pianofortesupply.com http://www.pianofortesupply.com On May 15, 2006, at 8:22 PM, pianotech-request at ptg.org wrote: > From: Bob Hull <hullfam5 at yahoo.com> > Date: May 15, 2006 7:54:23 PM PDT > To: pianotech at ptg.org > Subject: tuning pin bushings too big > Reply-To: Pianotech List <pianotech at ptg.org> > > > List, > > On a grand I'm rebuilding the old tuning pin bushings > were .41 od but I am unable to find a new set that is > anything smaller than about .44 od. > > Would you just not put in bushings on this one, or do > you have a quick method of reducing the size of the > bigger bushings? > > Thanks, > > Bob Hull -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: text/enriched Size: 1187 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/20060515/7fae6df0/attachment.bin
This PTG archive page provided courtesy of Moy Piano Service, LLC