Hi,Sy! Very impressive tool!!! Is that the one used by Stradivari in his days??? See you in Rochester! Isaac _____ From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Cy Shuster Sent: Sunday, March 05, 2006 12:03 PM To: Pianotech List Subject: Re: [Files] G-2 soundboard modification Have you tried the Hacklinger magnetic thickness gauge? Spendy, but lets you take more measurements without drilling: http://www.stewmac.com/shop/Tools/Calipers/Hacklinger_Thickness_Gauge.html --Cy-- ----- Original Message ----- From: Erwinspiano at aol.com To: files at ptg.org Sent: Sunday, March 05, 2006 12:07 AM Subject: Re: [Files] G-2 soundboard modification SO I decided to diaphramize this tubby little beast to seek improvement. I drilled small access holes (1.5mm) at the perimeter thru the board in the curved section under the plate. The nose bolt holes also serve this purpose. This allows for the wire end of a caliper to protrude thru the holes & the taking of initial measurements & also to track progess. -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060305/dd7d57c5/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC