Thank you Ed, One of the pivot blocks is pine and must be replaced. Gene ----- Original Message ----- From: <A440A at aol.com> To: <pianotech at ptg.org> Sent: Saturday, July 29, 2006 10:43 PM Subject: Re: back action replacement questions > > << Curious if red oak would do well as replacement mounting blocks for the > damper tray rather than maple? (I am a long distance from a hardwood > store) The > existing was bad as one side was pine and egg shaped in the pin hole - the > other side still original maple but suffering from the effects of the age > and > excess tray wobble. >> > > It would, I think, be simple to simply drill out a 3/8" hole directly over > the existing one, and install a plug of maple then redrill the hole. That > is > easier than making a block and trying to get the hole back exactly like it > was. > Regards, > > > > Ed Foote RPT > http://www.uk-piano.org/edfoote/index.html > www.uk-piano.org/edfoote/well_tempered_piano.html > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC