In a message dated 7/21/2006 3:18:29 PM Pacific Daylight Time, mfarrel2 at tampabay.rr.com writes: Any special recommendations for spacing the holes? Other than the obvious - measure old and space accordingly..... Maybe there is some sort of ultra-slick method (maybe not)? Could you buttress the old pins back into place by whatever method, CA or epoxy, to make sure the keys look right; then take a pattern off the tops of the pins, THEN yank the pins and rout out for an inlay? Maybe even two inlays, one for the sharps and one for the naturals. Bob Davis -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060721/5922b3e1/attachment.html
This PTG archive page provided courtesy of Moy Piano Service, LLC