In a message dated 7/21/2006 1:30:50 AM Eastern Standard Time, tcole at cruzio.com writes: The workaround is to scrap the brass rails and prepare the action rail to accept standard wooden flanges Greetings, Yes, I examined the hammer butts to see if I could convert them to the flange system, however, when I held a flange up next to the butt's center pin, they wont fit together in order to be pinned! There are flanges on the butt. Do you mean that the butts have to have those flanges ground/filed off, in order to make a regualar butt out of them? ..or are there special sized flanges that will accept those hammer butts? JUlia Gottswhall. Reading. PA -------------- next part -------------- An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060721/7ce30b36/attachment-0001.html
This PTG archive page provided courtesy of Moy Piano Service, LLC